Site Map       Back to Home     Privacy Policy    Japanese


Voices from customers

We've been delivering the products respecting customers voice.
Brief introduction from direct customer voices in this corner.
Customer B
( Steel Furniture manufacture)
We introduced YOSHINO Servo Panel Bender at the end of 2009.
For our application, the products is bended accordingly by 3 Press brakes. (3 operators)
In this time,by introducng YOSHINO bender,Just one operator made it possible to bend all side !
Also,easy-operation without physical burdens toghether !
Our curent facilities still were consisted of  hydraulic press brakes.
Introduction of "ECO" servo bender result in not only electric energy-saving,but
also maintenance- free due to no hydraulic.  
All of our operators is really appreciated to accept such cleannes.
In addition,your after-service is well take care of us.
Your performance & engneering also made us realize how good partner we have.            
Thank you

Servo Drive Panel Bender
Type: YSB-2515

For your inquiry, 

Click here
Comments by
YOSHINO Sales Officer
Our mission is much required for big impact of cost down to cutomers,specially after Leeman  Shocks.
"Customers always ask us to "suggest reducing production processes or saving
the times to  change lieu arrangements or " higher productivity by intensifying some processes."
In such circumstances,YOSHINO was fully reviewed and then made a decision to itroduce YOSHINO.
Ofcourse,Our product made good performance at the site and also
received they were happy with YOSHINO.
Once again we feel good to hear such a comment on introduction of YOSHINO servo bender
We also received comments on after-service and engineering capability.
Our further performance will be keeing on to the customer.
Thank you

Customer A ( Door
panel manufacture)
"" In this time,we introduced 1 set of YOSHINO servo drive panel bender.
We've been manufacturing the products by using 3 - 4 press brakes.
That's was time-consuming procedures in limited spaces.
After introducing YOSHINO,No need to change dies or transfer materials to next !!
It can be changed automatically.
YOSHINO  made it shorter cycle time, cost down &  increasing production volume !"
The merits of YOSHINO is as below in short ;
1. No flip-up operation by operator
2. Reducing physical burdens of operator
3. No manual change of the dies
4. Lower noise and user-friendly operation.
Comments by
YOSHINO sales officer
"" Thank you very much for your introduction of YOSHINO.
We,YOSHINO,really appreciated to hear your comments on our servo bender.
We've been supporting manufacturing processes to customers and then suggesting improvements of productions.
That's our sales policy to customers.
We're very much proud of receiving such comments as one of manufacturers.
It reminds us that our suggestions lead to customer's satisfaction in the field and was very confident in the products.
We are not only just supplier of the machinery, but also pursuing further advance for user-friendly machinery.""